Skip to content
หม้อแปลงไฟฟ้า QDTB®

China Transformer Factory — 100,000 m² Plant in Qingdao

QDTB manufactures oil-immersed and dry-type transformers, prefabricated substations and switchgear at a 100,000 m² plant in Qingdao, Shandong, China. Manufacturing has run on this site since 2001, with 500+ employees and exports to more than 30 countries. Core cutting, winding, cast resin and oil processing, assembly and routine testing all happen in the same plant.

100,000 m²
Manufacturing base
500+
Employees
2001
Founded
30+
Export countries

Inside the plant

QDTB transformer factory in Qingdao, China — production area A1
Transformer production, Qingdao plant
QDTB transformer factory in Qingdao, China — production area A2
Transformer production, Qingdao plant
QDTB transformer factory in Qingdao, China — production area A3
Transformer production, Qingdao plant
QDTB transformer factory in Qingdao, China — production area A4
Transformer production, Qingdao plant
QDTB transformer factory in Qingdao, China — production area A5
Transformer production, Qingdao plant

What we do in-house

Core cutting & stacking

Grain-oriented silicon steel and amorphous alloy cores are cut and stacked in-house, so core loss is controlled at the source rather than accepted from a supplier.

Winding

Copper and aluminium windings, foil or round wire, wound to the impedance and short-circuit withstand required by the order.

Cast resin & oil processing

Dry-type windings are cast under vacuum in epoxy resin; oil-immersed units go through oil processing and filling on the same site.

Assembly & tank fabrication

Tank fabrication, painting and final assembly for oil-immersed units and prefabricated substations are done in the same plant, not subcontracted.

Routine testing

Every unit is routine-tested before shipment: ratio, impedance, no-load and load loss, insulation resistance, power-frequency withstand, and partial discharge for dry-type units. A routine test report is issued with each unit.

Packing & export

Export packing, marking and documentation are prepared for FOB Qingdao shipment, with the datasheet, routine test report and GA drawing issued per unit.

Quality and compliance

  • ISO 9001 quality management
  • CE marking
  • Designed and tested to IEC 60076 / IEEE C57 / GB 1094 as specified
  • Routine test report issued with every unit
  • Type test reports available on request

Where we ship from

Shipments leave from Qingdao port on FOB terms. Each unit is issued with its datasheet, routine test report and general arrangement drawing; type test reports are available on request. Address: No. 50, Jifa Longshan Road, Environmental Protection Industrial Park, Jimo, Qingdao, Shandong, China.